DEMO-JOB / B / P-001

DRAFT — process inputs or review incomplete. Recipe: Illustrative workflow only / DEMO-1. Source: No production qualification

Time-compressed instructional storyboard. Actual tool motion, skive profile and waiting periods follow the entered procedure. Playback does not release equipment.

DEMO-JOB • revision B • P-001Recipe Illustrative workflow only / DEMO-1 • DRAFT — process inputs or review incompleteØ 1000.0 × face 1750.0 mm; developed 3141.592653589793 mm; all dimensions mmP-001-01P-001-01: effective 480.0; cutting blank 500.0 × 1800.0; stock #1P-001-02P-001-02: effective 480.0; cutting blank 500.0 × 1800.0; stock #2P-001-03P-001-03: effective 480.0; cutting blank 500.0 × 1800.0; stock #3P-001-04P-001-04: effective 480.0; cutting blank 500.0 × 1800.0; stock #4P-001-05P-001-05: effective 480.0; cutting blank 500.0 × 1800.0; stock #5P-001-06P-001-06: effective 480.0; cutting blank 500.0 × 1800.0; stock #6P-001-07P-001-07: effective 261.5926535897929; cutting blank 281.5926535897929 × 1800.0; stock #7Amber denotes joint allowance reference; actual skive profile follows the recipe.Blank trims/corrections are retained above; installed 3D mapping fits the steel circumference.

1. Identify and isolate

DEMO-JOB / B • P-001. DRAFT — process inputs or review incomplete. Confirm isolation and handling plan. Application: Demonstration head pulley; Not qualified for service.

2. Prepare steel and check conditions

Use the approved preparation and acceptance procedure.. Cleaner: Qualified cleaner required; Product document required. Environment: Record measured ambient and substrate conditions against the product limits..

3. Dry fit and prepare backing

Use the numbered cut map. Demonstration plain finish, drive-end reference required. Backing: Identify the supplied backing; follow its specified treatment.. Joint: Match the numbered pieces and closing allowance; consolidate per the approved procedure..

4. Identify, mix and coat

Enter the product-specific induction, pot life and tack window.

5. Place numbered pieces

Follow piece IDs and effective widths in the job drawing. Match the numbered pieces and closing allowance; consolidate per the approved procedure.

6. Consolidate and finish joints

Match the numbered pieces and closing allowance; consolidate per the approved procedure.

7. Cure under specified conditions

Record measured ambient and substrate conditions against the product limits.. Full strength: Start: Specified application event. Conditions: Manufacturer conditions required. Minimum wait: criteria-based; no time specified. Acceptance: Qualified acceptance required

8. Handling and finishing

Handling: Start: Specified application event. Conditions: Manufacturer conditions required. Minimum wait: criteria-based; no time specified. Acceptance: Qualified acceptance required Finishing: Start: Specified application event. Conditions: Manufacturer conditions required. Minimum wait: criteria-based; no time specified. Acceptance: Qualified acceptance required

9. Inspect and test

Record dimensions, seam condition and the specified bond test.. Bond method: Specified method required. Conditions: Specified test conditions required. Acceptance: Specified value and units required. Record actual results and deviations.

10. Authorize return to service

Start: Specified application event. Conditions: Manufacturer conditions required. Minimum wait: criteria-based; no time specified. Acceptance: Qualified acceptance required. Record inspector, date and disposition. Playback time is compressed and never authorizes release.